TEAR AID Patch Type AÂ provide a simple and easy method of patching holes and tears, as well as an excellent protective film solution.
Type A tear aid is a clear sticky patch that can be used to fix bladders, canopy and even reinforce leading edges.
Type A sticks to:
- Canvas
- Rubber
- Neoprene
- Nylon
- Most fabrics
- Plastics
- Polyethylene
- Polypropylene
- Polyurethane
- Sumbrella
- Non-oiled Leather
- Gore-tex
- Acrylics
- Fiberglass
- Aluminum
- Polyester
- Hypalon
- Dacron
Each pack contains 150 mm long by 77 mm of Type A Tear Aid Tape and 1 alcohol wipe for cleaning.
Check our other repair accessories!
How to:
- Clean the area with an alcohol wipe as if the area is not 100% clean the tape will just fall off.
- Dry with a hairdryer to make sure perfectly dry (not too much heat!) and hold dead flat.
- Prepare the patch by cutting to size and rounding off the edges, hold the area flat and apply the patch.
- You only usually get one shot at this so TAKE CARE! Press the patch firmly on and for the best results heat with a hair dryer and press again.
Reviews
There are no reviews yet.